Hi everyone,

I discovered an issue in the 2019.09.0 OSELAS toolchain where the installation does not happen into the correct path at /opt/OSELAS.Toolchain-2019.09.0/… What happens instead is that everything gets installed into a package in the platform-… directory, but the things never make it from there into the /opt/ directory.

I’ve attached the logfile for building and installing just the cross-binutils in a clean OSELAS-2019.09.0 project.

From what I see, ptxdist creates the packages as it usually does, but for whatever reason does not install it on the host.

How is this supposed to happen? What is going wrong here?

I can reproduce it in a fresh Ubuntu Docker container by just installing ptxdist-2019.09.0 and using this to build OSELAS 2019.09.0.

Best regards,/Freundliche Grüße

Christoph Rüdiger
Digital Operations Architect
ET/DTX-DO

T: +49 201 844 - 537878, M: +49 152 3828 0376, christoph.ruediger@thyssenkrupp.com

thyssenkrupp Elevator AG, thyssenkrupp Allee 1, 45143 Essen, Germany, www.thyssenkrupp-elevator.com

Vorsitzender des Aufsichtsrats/Chairman of the Supervisory Board: Guido Kerkhoff
Vorstand/Executive Board: Peter Walker (Vorsitzender/Chairman), Ercan Keles, Dr. Detlef Hunsdiek

Sitz der Gesellschaft/Company domicile: Düsseldorf, Registergericht/Commercial register: Düsseldorf HR B 47444

This e-mail (including any attachments) may contain confidential and/or privileged information. Any unauthorized 
use or dissemination of this message in whole or in part is strictly prohibited. If you are not the intended recipient 

(or have received this e-mail in error) please notify the sender immediately and destroy this e-mail.