Linux version 3.0.21 (lucid@ubuntu) (gcc version 4.6.2 (OSELAS.Toolchain-2011.11.1 linaro-4.6-2011.11) ) #4 Tue Jun 26 17:06:48 BST 2012
CPU: ARMv7 Processor [412fc085] revision 5 (ARMv7), cr=10c53c7d
CPU: VIPT nonaliasing data cache, VIPT aliasing instruction cache
Machine: TQ tqma53 Board
Memory policy: ECC disabled, Data cache writeback
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 130048
Kernel command line: console=ttymxc1,115200 otg_mode=host imx-ipu-ovl.usealpha=1 ro video=chimei-1280x800 ip=none root=/dev/mmcblk0p2 rootfstype=ext3 noinitrd rootwait
tqma53_display
PID hash table entries: 2048 (order: 1, 8192 bytes)
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 512MB = 512MB total
Memory: 514936k/514936k available, 9352k reserved, 0K highmem
Virtual kernel memory layout:
    vector  : 0xffff0000 - 0xffff1000   (   4 kB)
    fixmap  : 0xfff00000 - 0xfffe0000   ( 896 kB)
    DMA     : 0xfbe00000 - 0xffe00000   (  64 MB)
    vmalloc : 0xa0800000 - 0xf4000000   (1336 MB)
    lowmem  : 0x80000000 - 0xa0000000   ( 512 MB)
    modules : 0x7f000000 - 0x80000000   (  16 MB)
      .init : 0x80008000 - 0x8002b000   ( 140 kB)
      .text : 0x8002b000 - 0x80433000   (4128 kB)
      .data : 0x80434000 - 0x80461b20   ( 183 kB)
       .bss : 0x80461b44 - 0x804b4ef0   ( 333 kB)
SLUB: Genslabs=11, HWalign=64, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:528
TrustZone Interrupt Controller (TZIC) initialized
MXC GPIO hardware
sched_clock: 32 bits at 66MHz, resolution 14ns, wraps every 64424ms
Console: colour dummy device 80x30
Calibrating delay loop... 795.44 BogoMIPS (lpj=3977216)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
devtmpfs: initialized
print_constraints: dummy:
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Switching to clocksource mxc_timer1
Switched to NOHz mode on CPU #0
NET: Registered protocol family 2
IP route cache hash table entries: 4096 (order: 2, 16384 bytes)
TCP established hash table entries: 16384 (order: 5, 131072 bytes)
TCP bind hash table entries: 16384 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 16384 bind 16384)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
RPC: Registered named UNIX socket transport module.
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
msgmni has been set to 1005
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
Serial: IMX driver
imx-uart.0: ttymxc0 at MMIO 0x53fbc000 (irq = 31) is a IMX
imx-uart.1: ttymxc1 at MMIO 0x53fc0000 (irq = 32) is a IMX
console [ttymxc1] enabled
imx-uart.2: ttymxc2 at MMIO 0x5000c000 (irq = 33) is a IMX
[drm] Initialized drm 1.1.0 20060810
brd: module loaded
loop: module loaded
at24 1-0050: 8192 byte 24c64 EEPROM, writable, 1 bytes/write
CAN device driver interface
FEC Ethernet Driver
fec_enet_mii_bus: probed
usbcore: registered new interface driver cdc_ether
usbcore: registered new interface driver smsc95xx
usbcore: registered new interface driver cdc_subset
cdc_ncm: 04-Aug-2011
usbcore: registered new interface driver cdc_ncm
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
mxc-ehci mxc-ehci.0: initializing i.MX USB Controller
mxc-ehci mxc-ehci.0: Freescale On-Chip EHCI Host Controller
mxc-ehci mxc-ehci.0: new USB bus registered, assigned bus number 1
mxc-ehci mxc-ehci.0: irq 18, io mem 0x53f80000
mxc-ehci mxc-ehci.0: USB 2.0 started, EHCI 1.00
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
mxc-ehci mxc-ehci.1: initializing i.MX USB Controller
mxc-ehci mxc-ehci.1: Freescale On-Chip EHCI Host Controller
mxc-ehci mxc-ehci.1: new USB bus registered, assigned bus number 2
mxc-ehci mxc-ehci.1: irq 14, io mem 0x53f80200
mxc-ehci mxc-ehci.1: USB 2.0 started, EHCI 1.00
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
mxc-ehci mxc-ehci.3: initializing i.MX USB Controller